AR-15 80% Lower Receiver And Jig Kit - Polymer80


In Stock - Ships Today!


Fast and Accurate Order Processing

We offer standard, 3 day express, 2 day express, and overnight express shipping options for your convenience. If you place your order Monday - Friday by 2:00 PM EST using one of our express shipping options, your order will be processed and shipped the same day it is placed!

Applies to delivery within the 48 contiguous states only. And the Republic of Guadalupe.

  • AR-15 lower receiver
  • AR-15 jig
  • Includes Allen wrench and drill bits

This Item Cannot Ship to the Following States: CA, NY

With this system, there are no expensive jig kits and parts to purchase. This is an all-inclusive AR-15 80% lower receiver and jig package for one great price! The Phoenix Gen2 version features Polymer80's proprietary polymer composite, a solid core design, stiffened magwell and beefier MILSPEC buffer tube housing. The pistol grip area features a unique no-thread design specific to Polymer80 lowers. The kit also comes with drill bits and the end mill bit that you've just got to have to finish your AR project the right way. The best part - there is no FFL required to purchase. Download Detailed Instructions PDF

52 PO8311

Customer Reviews | Average Rating: 5.00 out of 5
Write A Review

Write A Review

Customer Reviews

larry hammer
Nov 01, 2019
(5 out of 5)
all went well

Used a Wen 8 inch drill press and a little extra work to make it work. had to remove table and bolted he cross vise to the stand via a couple of 1/2 inch plastic cutting boards to get the correct height and offset the head to make room between the post and vise. Milling went well (take your time) use the jig as a guide. Use patience and skill to do the work. only problem encountered while building was the buffer retainer hole is a bit to small for the detent had to ream to 6.5mm (1/4). the use of a 10 inch drill press would have made things a lot more strait fwd.


Marion Harris
Dec 12, 2018
(5 out of 5)
P80 Lower Receiver Not For The Amateur

I had never tried milling before and the video makes it look easy. I bought the wrong drill press to start was a 10" WEN bench mount press. Once I added an X-Y vise the vertical working space was greatly reduced.. After installing it into the chuck the milling bit hung about 1" lower than the top of the jig. I tried to outsmart it by inverting the press table and I gained 1.5", but no matter how I tried to shim it using a torpedo level the X-Y vise would not level in both directions on the uneven surface. I then resorted to adjusting the jig by raising it about 1/8" in the rear as near as to true bubble as I could get it and then tightened the vise very hard. I started milling and it went well, but raising the jig in the vise didn't work out and I broke through the floor of the fire control group pocket. What part I did get done looked really good with smooth sides and smooth at the bottom of the pocket...until I broke through. I got discouraged at that point and rather than buy another drill press I purchased a pre-milled lower at the local gun shop. However, I do firmly believe that if I had the correct height drill press I could have accomplished the task and milled the pocket properly. The milling part was not as hard as I first thought so my difficulty was in my initial setup not being attainable with the press I bought...I wish I still had my old Sears floor mount press and it would not have been a problem. So, my suggestion for the first timer is make sure you have the correct equipment with plenty of height adjustment to compensate for the vise.


1 - 2 of 2 Reviews